In our case, this is the Fa0/0 interface on R1. It is recommended to place the standard access lists as close to the destination as possible. Next, we need to apply the access list to an interface. The command above permits traffic only from the host with the IP address of 10.0.0.1. Upload a screenshot of the assessment items tab (in Packet Tracer). Complete the activity: 5.1.8 Packet Tracer - Configure Numbered Standard IPv4 ACLs.docx. Be sure you are using the latest version of Packet Tracer. We could also target the specific host by using the host keyword: R1(config)#access-list 1 permit host 10.0.0.1 5.1.8 Packet Tracer - Configure Numbered Standard IPv4 ACLs. access-list-number This is the decimal number of the ACL. Packet Tracer - ACL Demonstration In this activity, you will observe how an access control list. The command above permits traffic from all IP addresses that begin with 10.0.0. An inbound ACL filters packets before they are routed to the outbound interface. We can use the following command on R1: R1(config)#access-list 1 permit 10.0.0.0 0.0.0.255 First, we need to write an ACL to permit traffic from LAN 10.0.0.0/24 to S1. We want to allow traffic from the management LAN to the server S1. in means that ACL is applied to the traffic coming into the interface, while the out keyword means that the ACL is applied to the traffic leaving the interface. in and out keywords specify in which direction you are activating the ACL. You do that by using the ip access-group ACL_NUMBER in|out interface subcommand. Once the access list is created, it needs to be applied to an interface. You can also use the host keyword to specify the host you want to permit or deny: R1(config)# access-list ACL_NUMBER permit|deny host IP_ADDRESS ACL number for the standard ACLs has to be between 1вЂ“вЂ“1999.

Standard acl packet tracer activity 1